evilfij
March 12th, 2007, 01:20 PM
I pulled the jump seats out of the 110. They are cloth, the cloth looks great with no rips or anything.
I found all the belts. I also have the belt bars but only the front part where the seat belts mount, I do not have the bit that ties into the exterior cage. In any event it is mounted very solidly without that additional piece. One of the bars I had to weld back together as it was cut for removal by ECR so it has an extra seam on it. You could also just mount the belts to the tub with plates if you prefer.
What is wrong with them? Not much at the moment. The bottoms of the u shaped supports that sit on the floor when the seat is folded in the down position had surface rust which I cleaned up, sanded, sprayed with rust converted, primered, and painted. Some of the angle brackets that they mount with have some specs of rust through the sheridized coating (I think that is what they are coated in). They do not have the cloth straps to keep them tied up. You will need some bolts to mount them to your tub. All the other necessary hardware is included.
Anyway, they look great, don't look like they have been used much if at all and I would like to sell them.
$600 for the seats.
$150 for the belts.
This is less than half of new cost.
You can buy the seats without the belts but I will not sell the belts until the seats sell. I would sell in pairs if I have two buyers.
Ron
evilfij at yahoo dot com
please email as my PM is really full.
I found all the belts. I also have the belt bars but only the front part where the seat belts mount, I do not have the bit that ties into the exterior cage. In any event it is mounted very solidly without that additional piece. One of the bars I had to weld back together as it was cut for removal by ECR so it has an extra seam on it. You could also just mount the belts to the tub with plates if you prefer.
What is wrong with them? Not much at the moment. The bottoms of the u shaped supports that sit on the floor when the seat is folded in the down position had surface rust which I cleaned up, sanded, sprayed with rust converted, primered, and painted. Some of the angle brackets that they mount with have some specs of rust through the sheridized coating (I think that is what they are coated in). They do not have the cloth straps to keep them tied up. You will need some bolts to mount them to your tub. All the other necessary hardware is included.
Anyway, they look great, don't look like they have been used much if at all and I would like to sell them.
$600 for the seats.
$150 for the belts.
This is less than half of new cost.
You can buy the seats without the belts but I will not sell the belts until the seats sell. I would sell in pairs if I have two buyers.
Ron
evilfij at yahoo dot com
please email as my PM is really full.