PDA

View Full Version : Soft Top Door Tops, Door Panels

Bozman
August 13th, 2007, 11:32 AM
I have a set of soft top door tops and inner plastic panels I no longer need. I am willing to split either set up if I find buyers for the other half of the set. Buyer pays all shipping charges. PayPal is fine.

Door Tops: $600 for both ($350 if they are split up) Great condition, includes rubber gasket. These are tinted, but the tint is in great shape. Glass slides fine, I would recommend some stainless door studs as the existing ones are a little rusty.

Inner Panels: $200 for both ($150 for passenger, $75 for the driver's side) Both are in okay shape. The passenger side panel is in better shape of the two. No cracks, only missing plastic around screw holes as is standard for the door panels. I guess I would consider them to be in overall average condition.

MORE DETAILED PHOTOS AVAILABLE UPON REQUEST.
bryanf
August 13th, 2007, 01:38 PM
wanting to purchase,your door panels.sent you an email.
Bozman
October 27th, 2007, 12:36 PM
Door Tops still available.
Bozman
October 29th, 2007, 03:47 PM
Pics showing tint, as requested.
Bozman
October 30th, 2007, 09:23 AM
Pending payment, they are SOLD.

Thanks.
rmuller
October 30th, 2007, 09:40 AM
Anyone have any tips for installing door panels in similar shape? I'm missing a few of the outer screw holes on the panels I bought from another seller..
Bozman
October 30th, 2007, 10:09 AM
One key is not to overtighten the screws. Lightly hand tight is enough.

Also, you can try using some washers that sit on top of the plastic that is remaining. You will need longer screws for this.
rmuller
October 30th, 2007, 10:20 AM
Yeah, thats what I was thinking, either washers on there, or fab something out of plastic and epoxy it on there.. or possibly even bondo or something similar
Stmpede
October 30th, 2007, 10:34 AM
You can't do it with bondo. You could rivet a metal strap across the hole area and put a screw through that into the door but to be honest the washer idea sounds the best. Its quick, cheap, easy and clean.
cgalpin
October 31st, 2007, 07:57 AM
Or epoxy a metal strap across the back of the hole areas that are damaged and redrill the holes. I have found that due to the shape of the recess, the washer doesn't always work.
jaguiler
October 31st, 2007, 11:19 AM
a metal strap across the back of the panel seems to be the best solution, as mentioned above - then you just drill into the strap where the hole should have been - you can then rivet the strap to the panel. use a stainless steel strap