3 link

[snuffer]

Is a double cardon driveshaft needed when installing the SafariGard 3 link components.

If so is it because of vibration or other reasons.

Thanks.....Randy

[Berty]

I believe the SG 3 link allows adjustment of caster angles.

In the UK we only fit double cardon shafts after a lift, & only if you are getting vibes.

Brett

[TDI Guy]

Randy, the 3-link has nothing to do with the d-shaft. That will depend on the amount of lift you want. The 3-link will help adjust your caster closer to stock with any lift big or small

[snuffer]

Sorry, I should have mentioned that I have a Stage II lift.
Lifted it 2&1/2 to 3".

[TDI Guy]

YOu might need the cv shafts with or with out the 3link

[TwisteD90]

You NEED a CV drive shaft, as you don't want the stock one to fail on you which will cause a lot of damage and $$$.

Go with Tom Woods, and if I were you I would spend the extra $$ and get the double CV drive shaft.

[TDI Guy]

When I bought my 300tdi kit, it came with 2 new HD drive shafts. Could I just have the front one cut and add the CV for the top joint?

Randy

[TwisteD90]

Yes you can but expect to pay $300 for it and Tom Woods will do it for you.

[TDI Guy]

If thats the case, I will sell them.. THey are going up right now

[Buckon37s]

I run two rear shafts, you could always just give one to me as a spare for being such a swell guy :grin

[TDI Guy]

:evilfinge I need the $ to finish my truck or I would. Just kidding Dave...... :toast Did you make it to CC? Or were you beating KC all weekend? :stick Wwhere are my shock mounts??


Randy

[Buckon37s]

Well then fine :tounge I was going to send you a little cool something I had laying around for your truck but skkkrrreeewww that! :grin I did not make it to the CC, and your shock mounts are in the mail :rolleyes ;)