skid plate stabilizer bolt positions

[Marc Weinstein]

Anyone have a gas skid plate off the truck so I can get the positions of the welded-on receiver nuts for the rear stabilizer bar. I was part of a group of d-90 guys buying stainless cnc skid plates but didn't plan on the stabilizer nuts.

[dave_lucas]

Marc,

I have the stock skid sitting here in my shop, let me take some measurements and I will post them for you.

[dave_lucas]

Marc, I believe that these are the measurements that you are looking for.

Down at the bottom of the page
http://www.slickrockfabrication.com/d90skid.htm

Personally I would wait until I had the skid in place, then mark the holes. Take it back down and drill the holes, this way you are assured that the holes will be in the correct location.

Feel free to send me an email if you have any questions.