clearing fault code

[phunter]

I have tried the series of steps listed in the FAQ section. After switching the ignition off and hearing the relay drop, I still see code 17. I do not know if I have other fault codes, for I cannot get a blank screen.

When I kill the power I get code 02. After letting the truck idle for around 10 minutes, it idles down and then Check Enginecomes on followed by code 17. Any help would be greatly appreciated. I have repeated the steps of unplugging the code box afew times. Thank you.
My truck is NAS 110.

[bstraw]

Try This

Follow-up Post:

Here they are

[Hans]

Code 02 is nothing to worry about, it just means that the ECU was recent recently. Normally it goes away once you turn the truck off.

Code 17 indicates a failure of the throttle position sensor. Easy to replace, but a bit spendier than it needs to be... $60 or so for the part depending on where you go.

[thecatsmeow]

I had the identical fault 17 TPS just a few months ago. Easy access swap out, disconnect/reconnect the + terminal, start the truck, check code should stay 02 with no pesky check engine light on. I sourced the part from friend in Shelby, NC. Evan Amaya at Reborn Company. http://www.rebornco.com/ There is a Bosch generic.....looked identical, works fine. Morgan