Installing jump seats in D-90 ST anything i need to know?

[newbe90]

I Have a 1994 D-90 that had rear benches with no belts. I have removed the bench seats and i am ready to install the 4 jump seats (recently purchased from rovers north). Seems pretty straight forward screw and bolt. Is there anything that i need to know to perfect this installation.
thanks

[themaxx]

http://www.d-90.com/forum/showthread.php?t=9562

http://www.d-90.com/forum/showthread.php?t=8416

http://www.d-90.com/forum/showthread.php?t=4013

You can also call Eric at Trailhead4x4.com he's installed a few...

[GYM]

Do you have the offset mounting bars for the two center jump seat backs?

You might also check for conflicts with the speaker housings and the two rear seat bottoms.

Are you planning on installing seat belts?

[newbe90]

what exactly are the offset mounting bars? There does not seem to be a conflict with the seat backs and speakers. I just rested them in there it seams like there in no conflict /yes i have purchased seat belts and would like to install them

[GYM]

Click on the first link that Ade posted above. Look at the photos from CvC's post dated 9/26/06. Pics of the bar in photo 1. The offset mounting bar is required because the center rear jump seat back mount does not align with the holes in the tub.

You can also see how the seat belts mount. You will need the correct components under the wheel well to properly mount the seat belts to, as well as the inside bulkhead bar for the center jump seat female seat belt end.