PDA

View Full Version : ooops

ZACHASS
January 24th, 2009, 09:09 PM
Today I was taking out my tranny to replace my clutch and I t fell off the tranny jack and landed on the transfercase output yoke where the parking brake is and bent it.I can't find anybody who sells just this part.Does anybody know where to look or just try and find a used on this site.?I know it was a stupid mistake but it happens to the best of us .Atleast nobody got hurt! any help would be great thanks
headdamage
January 24th, 2009, 09:43 PM
Do you mean the drive shaft flange with the four bolt holes?
rover4x4
January 24th, 2009, 09:47 PM
maybe like a new output shaft or like transfer case?
ZACHASS
January 24th, 2009, 11:16 PM
yes ,where the rear drive shaft bolts to t/c.With the p-brake drum remove the flange is held to the output shaft with a 30mm nut.the output shaft does not look bent,just the flange.I think it might be easier to install the tranny and t/c seperate?Is the t/c is bolted to the tranny with only external bolts ?There is no internal bolts behind the inspection plate of the t/c holding it to the tranny?
TDI Guy
January 25th, 2009, 10:55 AM
No, just exterior bolts and linkage.. I'm sure someone has one on a scrap t case..
Roadsiderob
January 25th, 2009, 03:24 PM
PM me....I have a few.