90 parts blowout

[Ren Ching]

ROW 90 Parts available now

90 rolling chassis ok condition, new rear xmember $750 complete or $500 just the chassis
90 Rear bed fair condition $500
*Matte fender flares $250 set of 4
*Front ROW 90 fenders w/inner very good condition $350 each
*Stripped ROW 90 RHD Bulkhead fair condtion $350
*Station wagon ribbed roof VGC $1000
*Station wagon roof sides VGC $500 the pair
*RHD lower dash GC $100
*RHD heater GC $250
*RHD gauge cluster $100
*RHD dash vent cover (grey piece) $45
*brake pedal, booster, master cylinder $200
*90 grille ok, faded $20
4 spoke steering wheel faded $25
Steering lower arm (between box and column) $75.00
Old steering wheel (4 spoke) $25.00
Wiper Cover $40.00 OK, one switch added and surface rust inside
Shifter boot with foam NEW 20.00
Stalk cluster (wipers, turn, horn, headlights) 200.00
Front panel grill $50
Throttle cable 15.00
Gas Pedal Assembly $50
New Ignition switch 2 keys 100.00
defender TD5 bulkhead brand new $1200
Coniston green grille panel w/vent @ bottom $50
Plastic surround for 90/110 steering column $25
Bare rear door, wiper type, GC $75

let me know if you want pics. Items with a * are located in NJ so it may take some time to get that done.

Everything else is in Washington DC

[Abrooks]

what do you have for grill surroung and slam panel assemblies and hardware?

[JimC]

If the grill panel is not the "pushed out" AC type, and its not what Tony is trying to buy, then I will take it please.

[woldd90]

If the matte flares are in good to excellent condition, I will take them. Can you bring them to Uwharrie?

[Ren Ching]

what do you have for grill surroung and slam panel assemblies and hardware?slam panel is bent but useable with a bit of hammer work.

latch and crossbars included

surround is not the pushed out kind

scott, flares are in good condition, though at least one has red paint on it. I'll try to scare up some photos.

[Abrooks]

is surround vented for ac? does slam panel have rubber grommets and hardware? pics?

thx

[Ren Ching]

it is the one with the additional openings in the bottom section. no grommets or hardware.


is surround vented for ac? does slam panel have rubber grommets and hardware? pics?

thx

[130Tdi]

grill surround is from a td5. and is painted conniston. Bought it thinking I was getting the bump out type. Sold it to Ren Ching when it wasn't what I needed.


I might could need that rear door.Does it have glass in the hole ?

[Abrooks]

how hard would it be to get a pic of it?
thx

[Ren Ching]

here ya go

how hard would it be to get a pic of it?
thx

[61rover]

What condition is the rear door in?

[Ren Ching]

it is good, not great, hence the price. no significant corrosion. I will post a photo tonight

edit: may already be spoken for

edit #2 doug, have glass w/defrost, spade terminal is broken off the defroster $25

What condition is the rear door in?

[Abrooks]

sorry, i meant the grill surround

[Ren Ching]

forgot

90 blank roof sides $250 pair VGC
90 front inertia reel seatbelts VGC $195/pair

all located washington DC

ROW 90 Parts available now

Follow-up Post:

no pictures now but I think it is like this one:


anyway, it is in perfect condition. passing along the bargains given to me.


sorry, i meant the grill surround

[130Tdi]

it is good, not great, hence the price. no significant corrosion. I will post a photo tonight

edit: may already be spoken for

edit #2 doug, have glass w/defrost, spade terminal is broken off the defroster $25

Is that easier to fix/solder than my radiator ? Aren't there two spades on those.

[Stmpede]

Is that easier to fix/solder than my radiator ? Aren't there two spades on those.I bought a kit from NAPA to repair a broken line in the defroster in my J**p and it came with additional stuff to repair a spade connector that is broken off. You should be able to get a similar kit for $10-15 and repair it pretty easily.

[Ren Ching]

sounds good, thanks. doug I believe you are correct that there are two tabs

I bought a kit from NAPA to repair a broken line in the defroster in my J**p and it came with additional stuff to repair a spade connector that is broken off. You should be able to get a similar kit for $10-15 and repair it pretty easily.

[Ren Ching]

Randy, just confirmed the bulkhead is indeed td5, part # AHA 710450. Currently stored out of the weather...

new ones are upwards of $1600 @ RN

sounds good, thanks. doug I believe you are correct that there are two tabs

[Ren Ching]

pedal, booster, and MC SOLD
SW roofsides spoken for
Other stuff maybe spoken for:
flares
grill surround

Follow-up Post:

Also

Bonnet, red, no dents or rust. with 5 bar chequer plate $500
LT77 Seatbox good condition, battery box solid $100


pedal, booster, and MC SOLD
SW roofsides spoken for
Other stuff maybe spoken for:
flares
grill surround

[Ren Ching]

pics

[Abrooks]

I'll take the grill panel.

[JimC]

Dang!

[Abrooks]

Sorry, Jim, it will work perfectly for my oil cooler. Would an un-vented one work for you?

[JimC]

Yeah, an un-vented one is fine with me. I don't need a vent at the bottom.

[Ren Ching]

thanks d-90 source. few items left...

90 rolling chassis ok condition, new rear xmember $750 complete SOLD
90 Rear bed fair condition SOLD
*Matte fender flares SOLD
*Front ROW 90 fenders w/inner very good condition SOLD
*Stripped ROW 90 RHD Bulkhead fair condtion $350
*Station wagon ribbed roof VGC SOLD
*Station wagon roof sides VGC SOLD
*RHD lower dash GC $100
*RHD heater GC $100
*RHD gauge cluster $100
*RHD dash vent cover (grey piece) $45
*brake pedal, booster, master cylinder SOLD
*90 grille ok, faded SOLD
4 spoke steering wheel faded $25
Steering lower arm (between box and column) $75.00
Old steering wheel (4 spoke) $25.00
Wiper Cover $40.00 OK, one switch added and surface rust inside
Shifter boot with foam NEW 20.00
Stalk cluster (wipers, turn, horn, headlights) SOLD
Throttle cable 15.00
Gas Pedal Assembly $50
New Ignition switch 2 keys SOLD
defender TD5 bulkhead brand new $1200 (on hold for somebody)
Coniston green grille panel w/vent @ bottom SOLD
Plastic surround for 90/110 steering column $25
Bare rear door, wiper type, GC $75
Windscreen w/frame & hinges SOLD
Bonnet SOLD
Blank window sides SOLD

let me know if you want pics. Items with a * are located in NJ so it may take some time to get that done.

Everything else is in Washington DC

[wcampbel@nas.edu]

"Steering lower arm (between box and column) $75.00" - is this the bent kind like in NAS 90's or the straight one like in early Disco's?

[Ren Ching]

pretty sure it is the correct defender part. got it from stephen peters last year. on ym way up to Miane, will get back to you next week

thx
d

"Steering lower arm (between box and column) $75.00" - is this the bent kind like in NAS 90's or the straight one like in early Disco's?

[evilfij]

I have a NIB grill panel for you JimC.

[Ren Ching]

here's what is left/available:


*Stripped ROW 90 RHD Bulkhead fair condtion $350
*Station wagon ribbed roof VGC $750
Bare rear door, wiper type, GC $50
Blank 90 window sides VGC $250/pair

thanks D-90 source!

[Departing90]

Your prices are way too expensive! I have seen cheaper on e-bay by a long shot.:grin
Additionally i saw a station wagon ribbed roof on the local LA, Craigslist going for about $450- a few months ago.

[Ren Ching]

Hi guy!

Thanks for the input. I'm open to offers on all parts. no problem if anyone thinks it is worth less, I have researched stuff and based my prices on what I've seen, and think they are reasonable. Also not looking to earn profit at all, in fact I am just recouping what I spent and trying to get some space back in my small inner city yard, and reduce the burden on people who are graciously storing things for me. Please, by all means please feel free to make an offer if you see something you want and my price seems out of line.

On that note, what was the condition of the $450 roof. that is a pretty good deal for someone. And I spend more than a healthy amonut of time on ebay and don't recall seeing these items recently. Yeah, you can get a roof from down south for $200 but if you are in the NE US you will have to ship it, and it will have a hole. Mine has no holes, and is straight.

Cheers,
Dave

Your prices are way too expensive! I have seen cheaper on e-bay by a long shot.:grin
Additionally i saw a station wagon ribbed roof on the local LA, Craigslist going for about $450- a few months ago.

[PMKColorado]

upper dash crash pad & condition?
thanks,
Paul

[Ren Ching]

paul
I have it and believe it is in VGC. I'll go back and see what they go for. That part is in NJ and still attached to the bulkhead so may take a some time to get to it. IIRC it has a flip up ashtray in the middle.

best regards
dave

upper dash crash pad & condition?
thanks,
Paul

[Departing90]

Hi guy!

Thanks for the input. I'm open to offers on all parts. no problem if anyone thinks it is worth less, I have researched stuff and based my prices on what I've seen, and think they are reasonable. Also not looking to earn profit at all, in fact I am just recouping what I spent and trying to get some space back in my small inner city yard, and reduce the burden on people who are graciously storing things for me. Please, by all means please feel free to make an offer if you see something you want and my price seems out of line.

On that note, what was the condition of the $450 roof. that is a pretty good deal for someone. And I spend more than a healthy amonut of time on ebay and don't recall seeing these items recently. Yeah, you can get a roof from down south for $200 but if you are in the NE US you will have to ship it, and it will have a hole. Mine has no holes, and is straight.

Cheers,
Dave I said it was on LA, Craigslist not fleebay & the roof was fine going by the pictures & description!

Rovers down south is a business with all types of expenses involved & still manages to make a profit selling the roofs for $200- .

That hole is for a police light and was professionally cut & its no bigger than 1 ½ inches in diameter. I am sure Defender owners can come-up with a creative way of using it to their advantage & even if they cant I don’t think that hole is a $550- fix!

[JimC]

Time for a new thread. Re-consolidate your items in a new thread Dave, and this one gets axed.

[Ren Ching]

nevermind. thanks jim, I am fine with that.

I said it was on LA, Craigslist not fleebay & the roof was fine going by the pictures & description!

Rovers down south is a business with all types of expenses involved & still manages to make a profit selling the roofs for $200- .

That hole is for a police light and was professionally cut & its no bigger than 1 ½ inches in diameter. I am sure Defender owners can come-up with a creative way of using it to their advantage & even if they cant I don’t think that hole is a $550- fix!