Tubeless Valve Stems in NAS 110 Steel Wheels

[Stmpede]

When I purchased my 110 it has pull through valve stems in the steelies and tubeless BFG's mounted. I scrapped the stems when I had the wheels refinished, but the standard valve stems that we use at the dealer seem a little loose in the tube wheel valve hole. I mounted four of the tires last night and they hold air fine, but I am concerned about the valves not being tight enough when the tires are aired down for off-road use. I would like to replace the valve stems with a bolt in style, but I can't seem to find them in the proper diameter. What has everyone else done that has switched to tubeless on the NAS 110 steelies?

Thank you.

[Antichrist]

Generally the clamp style come with two grommet sizes included, for .453" and .625" holes. I got some really short ones at NAPA that fit my Wolf wheels.

[Stmpede]

Ok, I'll try NAPA then. Thanks Tom!

[JackW]

One thing to remember with some of the steel rims is that they don't have a bead retention lip to help keep the tire on the rim in case of low tire pressure - just a safety heads up.

[evilfij]

Why are you not running tubes? Tubes are good.