Brush Bar Bolts

[Campbell]

What are the bolt sizes for putting on a brush bar?

Thanks again

[Campbell]

Bump

[JimC]

IIRC M10 x approx 120 if you are talking about the ones that run through the bumper down into the chassis of which there are four required (in addition to the clip-on threaded plates that go inside the chassis. Are your's missing?

[Campbell]

Yes mine are missing. All I have is the bar.

I was going to go to home depot and try to find something to work. Any suggestions??

Thanks
Rich

Follow-up Post:

When I look into the holes I do see threads though/

[JimC]

But do you have a bumper attached? The brush bar is held down with the same bolts. I don't think you'll find a long enough m10 bolt at HD or Lowz. Evil probably has a set, and I might too if I can put my hands on them.

[Campbell]

Yes I have the bumper attached. I have 4 empty holes on the bumper that I thought is where the bar gets bolted down to. The ones that hold on the bumper seem to far back, but I will check when I get home from work.

Thanks

[Stmpede]

No, it is the same set that hold the bumper on. Depending on the brush guard, you may (probably will) have to drill a few extra holes in the bumper to mount the front of the brush guard to.

[Campbell]

Thanks