94 Square Tail lights switch to 95/97 ??

[mfreeman17]

Has anyone switched out the square tail lights on a 94 to use the circular 95/97 tail lights? Do the 95/97's fit without modification? Thanks for your help in advance.

[jstrong98]

I have a 94, just wondering , why do you want to switch them ?
Mine seem fairly simple to service/remove.
JS

[mfreeman17]

My buddy has a 97 and I just like the look of the circular lights better.

[RyanS]

I switched them on my 110 (I also like the look of the round lights better). I had to drill large holes for the plastic housing to fit through, and then also some small mounting holes. The lights have a connector so I also had to buy a pigtail that had the mating connector. I can find the PN if you need info. Also, on the 110, the roll cage is runs right behind where the two outside lights go. So I had to remove that section, and I still need to modify it to get it back in. Hopefully you won't have to do that on a 90.

[mfreeman17]

Ryan - thank you for the information. Do you have handy the PN info?

[RyanS]

Not sure what you've gathered up yet, but here's what I used:

(2) Stop Tailight Assemblys PN AMR6526
(2) Indicator Tailight Assemblies PN AMR6527
(1) Reverse Tailight Assembly PN AMR6528
(5) Tailight Plinths PN AMR3850
(3) Connector Repair Kits, 2-pin, PN LRN-00-0005
(2) Connector Repair Kits, 3-pin, PN LRN-00-0006

I bought this all through Rovers North. There are military lights that are better quality than these, but much more expensve.

[souza]

You might try Rovers Down South (www.roversdownsouth.com) for possibly better prices than Rovers North, I've gotten a replacement AMR6526 from RDS in the past.

[Doug_Paoletti]

I was thinking of changing out my 94 square taillights as well (don't like the look much). Can anyone identify these lights?

I deleted your Double post.:grin Mike

[RyanS]

Not sure if I'm remembering correctly, but I think those were made by Gulf Coast Rovers. But I think they were too expensive to make so they're not selling them. You might check with them anyway: http://www.gulfcoastrovers.com/

[TwisteD90]

They are LED lights, and Ryan is right they are expensive to make. If I remember correctly it cost them about $1000+ for the rear, front, plus some wiring so they blink right.

[evilfij]

LED lights have been advertised in the british LR mags that replace the big round lights. They were 20ukp each or so. I have seen in the US the oval fronts on a 94 in LED.

Personally I like the 94 style (I bought Ryan's old ones for my other truck). The 95-97 lights corrode.

Ron

[Doug_Paoletti]

Thanks, guys. Unfortunately, I don't have $1,000 in the budget for lights right now (at least not for taillights). They'll have to go on the long-term list.....

[Shane@EVS]

I'll second the problem with interference with the inner rollcage when trying to retrofit the newer round lights to a 94.
Only I was actually using a 97 tub so the holes were already there for the lights; but they(all) wouldn't fit due to the rollcage supports. I stuck with the 94 style lights.