Serial Link Mating Plug?

[Ramsay]

I believe that I have read in th FAQ's that I can reset my fault codes on my 95 ST through a short process that requires disconnecting the Serial Link Mating Plug. Which plug is this? And does this actually reset the fault codes and check engine light?

Thanks.

[Mike Hippert]

Yep you saw it here (http://www.d-90.com/faq/Engine/EngFault.html) . You have to pull the plug on the ECM. It will clear all the codes and the light. Do you know where to find the ECM?

[Ramsay]

I have no clue where the ECM is.

Thanks

[Mike Hippert]

I think on the 95s its under the passenger seat.

[Ramsay]

Yeah. All of the computer stuff is under the passanger seat. There is also the on-board diagnostic display where I am getting the fault number. I am just unsure of what is what once I am looking at it. I am a little worried about unplugging the wrong plug. At the same time I dont really want to pay someone else to do it =)

[Mike Hippert]

I'v unplugged mine a couple times. I have also disconnected the battery and that cleared the code also. I had the battery off for a while so if it does not work right away you may have to wait a while.

[Ramsay]

Could you describe the ECM and what it is that i need to unplug. Small? large? 5 plug? goes from where to where? Thanks so much for your help.

Andrew

[Mike Hippert]

No problem, it should have a big plug on it and about 20 or 30 wires coming out of it. I can take pics of mine in the AM if you don't mind waiting.

[Ramsay]

Mr. Hippert. Thank you very much. The pesty check engine light has gone away. The onboard diagnostic display says nothing so everything is great. Thanks for your help and you saved me a few bucks.

Andrew

[Mike Hippert]

Cool!