Lucas problem; need part number

[sherpamike]

I need to replace the part that I am holding in the pictures. The part is the 'middle' piece of the rear light/brake light assembly.

These short (1"?) plastic assemblies go between the wiring harness plug and the light bulbs themselves. My problem is that the electrical contacts in the housing are corroded and do not allow electrical conductivity. Plus, one of the connectors actually broke off.

Can anyone look up the part number for this Lucas piece of crap? I would actually like to replace both this piece that is part of the left light assembly and its counterpart in the right light assembly. The left and right pieces look to be different; so can anyone look up both of the part numbers? Thanks in advance

-Mike

[sherpamike]

Here is another picture of the inside of the piece that I need. If you look close enough you can even see where the connector that broke off used to be.

[rover4x4]

I think George at RDS has the replacement, its the entire assembly with the lens etc.. I think about 18$ I was replacing the reverse light lens on my truck...

[rover4x4]

o yeah its under the "lamp parts" section. www.roversdownsouth.com

[dnewman9]

I got the same part from LR directly, I think I paid $22 bucks locally. The tips inside corrode and break.
May check with LR so you dont have to wait for shipping.
Dennis