PDA

View Full Version : Misc. D90 parts for sale

Chris Cox
October 28th, 2003, 02:52 PM
I have a few parts for sale for a Defender. They are:

NAS rear step bumper, good condition, $250 + shipping

NAS ST rear tire carrier, has some rust, mounting hardware for mounting to truck is missing, $100 + shipping

V8 chassis crossmember (under tranny), good condition, $20 + shipping

front and rear sway bars, good condition, $50 each shipped

ST door tops, in good condition, drivers door has a very small amount of paint rubbed off at the top corner that needs to be touched up, make me an offer (would rather sale as a pair)

Load of bits out of the engine bay for a 3.9L V8, cheap. If you need something, ask, as I may still have it.

Brand new LR 300tdi intercooler, 300tdi turbo hoses, air filter, make me an offer on the lot.

Thanks

Chris
Chris Cox
October 28th, 2003, 08:08 PM
I also have door panels off of a 94 ST for sale. Both are in good condition, and include pull handles for inside. Make an offer.

Chris
Doug
October 28th, 2003, 08:36 PM
Chris,

I'm thinking of putting a sway bar on the 110 front end. The NAS 110s were all shipped without a front bar. Off hand, I'm wondering if the fittings are all there for the bar to just plug in.... Any ideas?

Doug Walker
mattdh
October 28th, 2003, 10:18 PM
chris did you say your v8 cross member was galv. saw your post on the sway bar thanks.but i was told i could use the ball joint off my rear sway,might go that route
Campbell
October 29th, 2003, 07:28 AM
do you have a sealed a/c compressor?
Chris Cox
October 29th, 2003, 07:33 PM
The crossmember is not galvanized. No AC parts. As far as I know, the front axles on 110's and 90's are the same.

Chris
leafsprung
November 3rd, 2003, 09:42 PM
Interested in the Door Tops. Email me at:
lemurstew@aol.com

-Regards
-Ike Goss
rover_rich_d90
November 10th, 2003, 05:02 PM
You wouldn't happen to have a Transfer case that's in good condition would you?

Cheers,
Rich
Chris Cox
November 10th, 2003, 10:49 PM
Sorry, transfer case has been gone. Door tops and panels are no longer for sale, as I missed a deal on some SW doors, and have been able to find a good deal on some new ST doors. Crossmember, bumper, and roll bars are gone.

Thanks

Chris
vnrover
November 13th, 2003, 03:51 AM
Chris, would u happen to have a fender flare (in good shape) available from the parting-out?

Thanks,
Paul