D90user
April 13th, 2011, 04:46 PM
Does anyone know what the gap should be on the front of the withdrawal sleeve when replacing the cross shaft/ fork?
I have an old manual and it tells me 15/16 in from the back of the withdrawal mech to the bearing. But I cant get my calipers to measure because they are too big to fit in there.
Does anyone know what the measurement should be on the front of the sleeve when getting the cross shaft/fork set?
cheers
I have an old manual and it tells me 15/16 in from the back of the withdrawal mech to the bearing. But I cant get my calipers to measure because they are too big to fit in there.
Does anyone know what the measurement should be on the front of the sleeve when getting the cross shaft/fork set?
cheers