bd90
August 25th, 2004, 09:36 PM
The measurement I need is the height of the floor bracket on a factory rear bench seat (from the floor to the top of the pin on the bracket). These are the ones that bolt to the floor and allow the seat to tumble forward. I am installing the seat and belts and have everything but these brackets. I've got some for a Jeep rear seat that are very similar to the drawing in the LR install instructions. If the height of the LR bracket is close to what I've got I'll just make the Jeep ones work. If not, I'll either try and make some or buy some if there are any that someone doesn't need anymore. Thanks in advance, Brian