Any one have a crank shaft for 2.0 and 2.25 ?

[Chris Velardi]

A friend is looking for a crank shaft for 2.0l and 2.25l series engines any have one have either they want to sell?

[Albersj51]

George, at RDS, has new 2.25 crankshafts listed on his site under Series Engine Parts, for $297.

Jason

[o2batsea]

Diesel ones are forged. They fit the gasser as a nice bottom end upgrade.

[Chris Velardi]

So sorry , It appears my friend needs a crank handle (so the series truck 2.0l and 2.25l can be started by hand... not the crankshaft !

[o2batsea]

Tell him good luck with that. I never could start the 2 1/4D with one. Maybe the gassers are easier. I think those were more an appearance item than actually useful. I usually could get the truck going if I could push it up to walking speed then bump it in 1st. If it was pointing uphill I would bump it in reverse.

[brn24whl]

http://www.roverparts.com/Parts/8195.cfm

In stock new

[Chris Velardi]

They are gas engines he has , Bill I was thinking the same thing with the hand crank on the front of my 101FC , now that is has a 4.6 in it I'm quite sure the hand crank will always be for aesthetics