Fog light install

[SFD90]

I'm installing Hella fog lights on the front bumper and need some help. I haven't see how it's "supposed" to be done from the factory so I'm not sure what I'm aiming for.

Currently all I have are the two lights. There are two holes (too small) in the front bumper between the factory brush bar. I assume I should mount them there, but then they're not high enough to clear the cross-member on the brush bar. Is there supposed to be a mount or something?

Then I need to wire them. Where can I get the necessary harnesses, wires, switch, relays, etc.? And is there a LR switch that is supposed to be next to the dimmer? There is extra space there and I was wondering if that is where it should go.

Thanks in advance as always.

[rover4x4]

you need this

[rover4x4]

another

[rover4x4]

mounts in conjunction with the brush bar/bumper the lights sit on top.. It took me a while to find one. uh.. which hellas do you have?

[rover4x4]

this will hopefull help give and idea. you can see the mount and all

[javelinadave]

Payton,
www.roversnorth.com sells the matching switch to the dimmer switch. Part # RNC938....$24.79. Good luck...Dave

[lobster]

You can buy that bar at a dealership. That is where I got mine then sold it to Philip, sucker! Just kidding Philip.

[rover4x4]

took me a while to find it tho :evilfinge

[SFD90]

Damn, thanks for the help guys. Of course it couldn't be easy. I'll look for that bar and hopefully get the switch for a clean install.

[Eric Siepmann]

Payton,

Which switch? There is an Auxiliary lighting swith that fits next to your dimmer and there is a wand switch that fits on the right hand side of the steering wheel.

EwS

[SFD90]

I'm assuming I want the aux. switch next to the dimmer. I think that'd look best and be as close to stock. Where can I find a wiring diagram or what relays to use?

BTW, I have the Hella FF1000s and I think they're considerably smaller than the ones posted earlier in this thread, the Rallye 3000s.

[rover4x4]

the 4k's will not work in conjunction with the stocker bar. you would have to cut the grill.... i am gonna get a little bracket that will move the light out just enough to fit the depth of the 4k's. the switch that goes on the steering colum is kinda $$ from rovers north.......

[Eric Siepmann]

The Steering column switch is nice though.

Phil,

Try the RN stainless grill. It's much nicer than the stock and it is much thinner. Might work w?o mods.

EwS

[rover4x4]

I think i am gonna shell out for the colum switch. I have seen the RN grill its nice but to bling bling for me.

[Eric Siepmann]

Yeah, the silver one looks Bling. But the black looks real stealthy. Hard to tell it's even there.

Are you running a winch? I just looked at my SW and it looks real crowded up there. I hope that I can stuff the lights up there....

[rover4x4]

me no winch.