SafariResto
August 27th, 2006, 06:22 PM
I have a complete 4.6 set up to run with 4.0 Gems. The coil pack, Left (I think) exhasut manifold and MAF have been sold speratly.
Purchased at 19k, torn down and sent to the machine shop for a check out, polished the crank, then reassembled with genuine new bearings, Cam, Crank, Mains, etc. New heads, water pump, new starter, new altanator etc etc etc....
Put about 3k miles on the engine before parting the truck out. I just ordered a 300 TDI with Auto and have to pay for it. This will be the complete engine minus the flywheel and what was mentioned above, as I had it mated to a 5 speed.
Located in Orlando, would ship in two to three days.
2800.00 OBO
407.782.7713
Purchased at 19k, torn down and sent to the machine shop for a check out, polished the crank, then reassembled with genuine new bearings, Cam, Crank, Mains, etc. New heads, water pump, new starter, new altanator etc etc etc....
Put about 3k miles on the engine before parting the truck out. I just ordered a 300 TDI with Auto and have to pay for it. This will be the complete engine minus the flywheel and what was mentioned above, as I had it mated to a 5 speed.
Located in Orlando, would ship in two to three days.
2800.00 OBO
407.782.7713